Tag Archives: amplifier circuit


 

1.5W Audio Amplifier with IC SSM2211

This is 1.5W audio amplifier circuit design based on wide bandwidth, low distortion power IC SSM2211 from Analog Devices. This circuit is simple, inexpensive and easy to built with only contains few components. The SSM22111 is a high performance audio amplifier that delivers 1 W RMS of low distortion audio power into a bridge-connected 8… Read More »

35W Power Audio Amplifier based LM391

Here the 35W power audio amplifier circuit based on LM391. Inductor L1 is constituted by 20 coils of wire, with thickness 0.9mm, round resistor R16. The transistors Q3-4 are the final amplification section, it should be placed on heatsink. If are used the Q3-4 in packing TIPxxxx they can be placed straight above in PCB.… Read More »

Dynamic Microphone Amplifier

Here is the dynamic microphone amplifier circuit diagram. This circuit should be perfect for dynamic microphone… Dynamic microphones are versatile and ideal for general-purpose use. They use a simple design with few moving parts. They are relatively sturdy and resilient to rough handling. They are also better suited to handling high volume levels, such as… Read More »

22W Stereo Power Amplifier with TDA1554

Here the circuit diagram of 22W stereo power amplifier. Powered with main power IC TDA1554Q, this circuit works up to 22W for each channel. For stereo channel, the power output should be up to 2 x 22W . A few externel components required to support the main component. Heatsink on the power IC is a… Read More »

70W High Power Amplifier with MOSFET

Here the schematic diagram of 70W power amplifier with MOSFET for your audio system. There are possible alternative input stage transistors, the Toshiba 2SA970BL and 2SC2240BL, which appear to be good substitutes for the Hitachi 2SA1085E and 2SC2547E. The ‘BL’ suffix is the high gain group. Alternatives for the Sanyo 2SC2911 and 2SA1209 are the… Read More »

2x10W Audio Amplifier with TDA2009A

This 2x10W audio amplifier circuit power output will be 10 watt on each channel with 4 ohm speaker resistance. The supply voltage required for this circuit is 8 – 24V DC at 1 to 2 Amps. Maximum output power will only be obtained with a power supply of at least 20V and greater than 1.5… Read More »


Page 1 of 212


Schematic Diagram

In the electrical sector, a schematic diagram is usually used to describe the design or model of equipment. Schematic diagrams are usually utilized for the maintenance and repair of electronic and electromechanical devices / units. Original schematics were made by hand, using standardized templates or pre-printed adhesive symbols, but nowadays Electrical CAD computer software is often used.

In electronic design automation, until the 1980s schematics were virtually the only formal representation for circuits. More lately, using the progress of computer system technology, other representations were introduced and specialized computer languages were developed, because with the explosive development of the complexity of electronic circuits, classic schematics are getting less practical. As an example, hardware description languages are indispensable for contemporary digital circuit design.