Mic Compressor
Below is a mic compressor circuit that uses transistors as active components. VR1 and VR 2 is used to control the tone from the microphone, while VR3 and VR4 strengthening works to control the audio signal in the compressor mic. C10 must be used in this circuit.
The circuit I got from my local computer store but I have not tried to assemble this circuit. I am sure this circuit worked perfectly because the kits sold in the market from this circuit.
Recent Posts
Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
Horn and Lamp Flasher Circuit for Car Reversing Gear Mode
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
Alarm Circuit for Drinking Water
This is the circuit diagram of drinking water alarm based a small water sensor by…
200W MOSFET Amplifier based IRFP250N
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
300W RMS Stereo Power Amplifier based IC TDA7294
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
Stereo Tone Control with Line In + Microphone Mixer
This is an active stereo tone control circuit using very well known op-amp IC of…