Categories: Guitar Effects

Dan Armstrong Green Ringer Guitar Effect

This is Dan Armstrong Green Ringer guitar effect for your electric guitar. The guitar effect is sold at high price at the market. Now, you can build your own low cost guitar effect… 🙂

The transistor marked ” * ” has no markings other than three stripes: green, blue and white from top to bottom. It is probably a log gain NPN used as a dual diode with the anodes connected together at the base of the final transistor.

The continuity test on the device shows no conductivity except that the topmost pin conducts when it is positive of the pins in the middle and other side; otherwise, no conduction. This  is I would expect if it were an NPN with the same pinout (base, collector, emittor) as the other transistors.

This circuit operated with 9V supply. Use battery or regulated power supply for better result.

circuit diagram

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago