Here the circuit diagram of octave fuzz guitar effect pedal. This guitar effect unit is great sounding octave fuzz, with an optional mode of just fuzz. The fuzz is really a absolutely rectified signal and is fairly chewy. For some the Fuzz alone could possibly not be loud enough, this could be fixed by raising the value of the 820 ohm resistor and lowering the 39k one. Or one could just replace both having a regular volume potensiometer for a extra typical approach. The “struzz” will be the fuzz with an octave greater signal mixed in. Great for signal notes and leads.
Octave Fuzz Pedal Circuit Notes:
Download Octave Fuzz Pedal circuit diagram in PDF File from below link:
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
I built this circuit years ago (15?), and finally got it back out a few months ago. There were several mods at the time that weren't on the schematic, and I couldn't get it to work. Luckily, I still had all my notes on it, and sorted it out. It's everything you said it was! Great