Hobby power supply for electronic hobbysts. This is power supply circuit which have 2 output that are static output and adjustabled output. The static output is stabled and regulated output. The circuit is based around the 7805 voltage regulator. It has only 3 connections (input, output and ground) and it provides a fixed output. The… Read More »
Here the 20 band graphic equalizer schematic diagram. This is stereo graphic equalizer, it should be 2×10 channel equalizer. Graphic equalizers device are popular with both domestic users and professional users. This equalizer is has simple design and easy to construct. It has no coil. It uses 15V split / dual polarity power supply to… Read More »
The circuit diagram of 3V-30V/3A adjustable regulated power supply. This is an adjustable and regulated power supply with stabilized DC voltage between 3V and 30V provided that the consumption does not exceed 3A direct current. This circuit featured with short circuit protection and overload protection. This power supply unit can be used for general purposes,… Read More »
This is running LEDs circuit which use timer ID NE555N and logic IC 4017N. IC 555 act as a multivibrator and generate frequency to be used for 4017 clock input.
Here the schematic diagram of 70W power amplifier with MOSFET for your audio system. There are possible alternative input stage transistors, the Toshiba 2SA970BL and 2SC2240BL, which appear to be good substitutes for the Hitachi 2SA1085E and 2SC2547E. The ‘BL’ suffix is the high gain group. Alternatives for the Sanyo 2SC2911 and 2SA1209 are the… Read More »
This 2x10W audio amplifier circuit power output will be 10 watt on each channel with 4 ohm speaker resistance. The supply voltage required for this circuit is 8 – 24V DC at 1 to 2 Amps. Maximum output power will only be obtained with a power supply of at least 20V and greater than 1.5… Read More »
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram:
This is a sound generator based on general purpose timer IC 555. A flip-flop circuit is included, so this circuit will give sound output and blinking LED. There are 2 modules in this circuit that are flip-flop / LED flasher module and sound generator circuit modules which combined in one schematic diagram. This is a… Read More »
This is a 18 Watt audio amplifier circuit based on power IC HA13118. The supply voltage required for this circuit is 8 – 18V DC, at least 1 to 2 Amps. Maximum output power will only be obtained with a power supply of 18V at greater than 2 A, using a 4 ohm speaker. The… Read More »