Categories: AudioSpeaker

Passive Surround

This is the scheme diagram of passive surround circuit. Passive surround doesn’t need any active components and power supply to make the circuit works. The circuit just need the combination of resistors and electrolytic capacitors.

Circuit Notes:

  • This passive surround circuit MUST be connected after power amplifier module.
  • Use full range type of loudspeaker. Do not use woofer or tweeter speakers for rear speakers.
  • Left Front and Right Front can be speaker box contains woofer and tweeter.
  • 5W resistors is a must, 1/4 or 1/2 watt resistor will make it burned.

Loud Speaker Position:
LF : Output > connect to Left Front Speaker
RF : Output > connect to Right Front Speaker
LR : Output > connect to Left Rear Speaker
RR : Output > connect to Right Rear Speaker

Switch operations:
1 : Quadrophonic
2 : Surround
3 : Stereo (passive surround deactivated, Rear Speakers disconnected)

circuit diagram

View Comments

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago