Categories: Linear Amplifier

140W Power Amplifier

The following is a circuit of a power amplifier 140W. This Circuit using 741 IC-based circuit opAmp as strengthening early before the final strengthening by four transistors thereafter. Make sure you use a heatsink on the transistors to reduce excess heat in the transistors.

Power supply used is the type of dual polarity power supply with (+), (-) and (0). For maximum performance, use a stabilized power supply with 40V output voltage and output current of 5A. Do not forget to use the good speakers to get good audio output as well .. 🙂

Good luck …

circuit diagram

View Comments

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago