The following diagram is the circuit diagram of low cost 12V stereo tone control which also available in kit, you may find the kit at electronic part store around your place. The circuit build based on ordinary tone control circuit, using two low cost transistors FCS9014 in each channel, so there are will be four… Read More »
The following circuit is a 5W stereo audio amplifier, built based on single amplifier IC TA7227. The TA7227 can be used for dual mode (stereo amp) and single mode (bridge connection/mono amp). This IC type featured some circuit protection: thermal protection, over voltage protection, current limitter and BTL DC short connection. The tone control circuit… Read More »
This is an 250mW RF power amplifier circuit project. This circuit is designed to amplify the output of about 7mW wide band FM transmitters to a final level of about 250mW. General purpose 12V DC power supply can be used to operate this RF amplifier circuit. Schematic Diagram: Components List: R1 ____________________ 10R R2 ____________________… Read More »
This is another stereo / dual power amplifier circuit with power IC KA series. This amplifier delivers dual power output (stereo) at 1.2W for each channel. General The KA2214 is a monolithic integrated dual audio power amplifier in a 14-pin plastic dual in line package. It is designed portable audio sets.
This is a class AB 6-10W audio power amplifier circuit which built using a TDA2002 or TDA2003 power amplifier IC module. These are replacements for the original LM383 which is no longer available. It is easy to build and has a minimum of external components. The module has both short circuit protection and thermal protection.… Read More »
Above schematic diagram is a small 325mW amplifier circuit based on LM386 with a voltage gain of 200 that can be used as a simple bench amplifier, signal tracer or used to amplify the output from personal radios, MP3 players, MP4 Players or iPods.
This 2x10W audio amplifier circuit power output will be 10 watt on each channel with 4 ohm speaker resistance. The supply voltage required for this circuit is 8 – 24V DC at 1 to 2 Amps. Maximum output power will only be obtained with a power supply of at least 20V and greater than 1.5… Read More »
This is a 18 Watt audio amplifier circuit based on power IC HA13118. The supply voltage required for this circuit is 8 – 18V DC, at least 1 to 2 Amps. Maximum output power will only be obtained with a power supply of 18V at greater than 2 A, using a 4 ohm speaker. The… Read More »
This is 2 x 3W stereo audio amplifier based on IC power BA5406. This circuit which will give you 3W power in each channel. This circuit will be great for indoor audio system. Components List: R1, R2 = 120 ohm R3, R4 = 2R2 ohm C1, C2, C11, C12 = 220nF nonpolar capacitor C3, C4,… Read More »