In the above circuit diagram, a CMOS operational amplifier (op-amp) controls the current via a P-Channel HEXFET power transistor (IRF9520) to maintain a constant voltage across R1. The current is given by: 1 = VREF/R1. The benefits of this configuration are:
This is the positive voltage regulator circuit with PNP Boost transistor: The IC8211 presents the voltage reference and regulator amplifier, while Q1 will be the series pass transistor. R1 defines the output current of the IC8211, while C1 and C2 present loop stability and as well act to suppress feedthrough of input transients to the… Read More »
Here the simple, low cost and easy audio booster circuit. It uses a transistor of 2N3392 ad the main amplifier. Component List: R1 = 47K R2 = 470K R3 = 10K R4 = 560R R5 = 270R C1 = 0.1uF/25v C2 = 3.3uF/25v C3 = 470uF/25V P1 = 100K Q1 = 2N3392 D1 = 5mm.… Read More »
This cut phone line detector circuit is used to detect whether your phone line is active or not. Components List: R1,R2,R3 = 22M Ohms R4 = 2.2M Ohms C1 = 0.47uF/250V Mylar caps D1 = 1N914, NTE519, or other small signal diode Q1 = 2N3904, NTE123AP Q2 = 2N3906, NTE159 Q3 = IRF510, NTE2382, MosFet
Privacy Policy for circuitdiagram.net If you require any more information or have any questions about our privacy policy, please feel free to contact us by email at atikasyanti@gmail.com. At circuitdiagram.net, the privacy of our visitors is of extreme importance to us. This privacy policy document outlines the types of personal information is received and collected… Read More »
This is an easy FM tracking transmitter circuit project :). The scheme designed by Tony van Roon, and here the FM transmitter tracker diagram: Components List: R1 = 10K C1 = 100uF/10V C2 = 10nF C3 = 4-40pF trimmer capacitor C4 = 4.7pF IC1 = LM3909 Q1 = 2N3904 NPN transistor LED1 = Red LED/or… Read More »
Touch alarm circuit is widely used for security, which is installed on the door. The advantages of this alarm is because the cost is cheap and difficult to detect by burglars / intruders. The following is an example of a touch of alarm circuit which is designed by Tony Van Roon. Components List: R1 =… Read More »
This document contains schematic diagram of Orange 125MK3 including the guitar preamp section, feedback and power amplifier section. Preview:
The following diagram is an inverter circuit which will give you 220V AC 50Hz with maximum power output of 100W. This inverter built using transistors for both the square wave generator module and the amplifier module. Inverter Diagram: The Q1 and Q2 used generate square wave. Q5-Q8 amplify the signal and the transformer to increase… Read More »