The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »
This is a inexpensive high fidelity (hi-fi) tone control circuit designed just with two low cost transistors as the active components. The schematic is one channel (mono) tone control, build the similar circuit will make it become stereo channel. This Hi-Fi tone control circuit can be operated with wide range supply voltage, 12V – 24V… Read More »
Below circuit is an echo chamber circuit which can be used for smoothing your voice from the microphone. This circuit may used for any kind of audio signal (microphone, radio, mp3 player, etc). The echo chamber circuit is great for human voice (karaoke), i doesn’t needed for music sound. This circuit is quite complex with… Read More »
This circuit is a wireless car alarm system that is built using two circuit modules, namely modules of transmitter and receiver modules. This circuit works on FM radio waves. Car alarms can be used on vehicles that have a 6-12VDC power supply. You can use the voltage stabilizer if your car power supply is too… Read More »
This is a class AB 6-10W audio power amplifier circuit which built using a TDA2002 or TDA2003 power amplifier IC module. These are replacements for the original LM383 which is no longer available. It is easy to build and has a minimum of external components. The module has both short circuit protection and thermal protection.… Read More »
This is the sound generator which will simulate British police car siren. The circuit is built using 2 pieces of timer IC 555 to generate sound frequency. How the circuit work:
This is the circuit diagram of UHF band TV antenna booster with 15dB gain power. This low cost antenna booster is simple and easy to build.It use single transistor BF180 to boost te UHF signal. Since this is an active circuit of UHF TV antenna booster, it will require a 12v power supply to operate.… Read More »
This 2x10W audio amplifier circuit power output will be 10 watt on each channel with 4 ohm speaker resistance. The supply voltage required for this circuit is 8 – 24V DC at 1 to 2 Amps. Maximum output power will only be obtained with a power supply of at least 20V and greater than 1.5… Read More »
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram: