This is high fidelity, high quality 25W HiFi audio amplifier circuit delivers great audio performance. You don’t need pre amplifier circuit for this design since it can be directly connected to the input devices such as computers, phones, radios, TVs, etc. Component list: R1,R4 = 47K 1/4W Resistors R2 = 4K7 1/4W Resistors R3 =… Read More »
This is 20 watt audio amplifier circuit design which use IC LM1875 as main component. This circuit is simple and very easy to built. For stereo channel, you need to build the two same circuits which will amplify the both of audio channels (right and left channel). Dual polarity / symmetrical power supply required for… Read More »
This is a low-cost and simple intercom circuit design. Some intercom circuits is build by applying integrated circuits. The circuit described right here utilizes 3 certainly transistors which easy to find on the electronic store. Even a newbie can assemble it on a piece of veroboard without difficulty. The circuit consists of a 3-stage resistor-capacitor… Read More »
This is a A/B Box switch pedal schematic with two inputs and one output and featured with dual operational amplifier modules. This circuit was designed by Rick Barker. This A/B Box effect was originally designed for switching between different harmonica mics. This A/B Box featured low noise dual preamp for better performance.
The following scheme diagram is the circuit diagram of VOX treble booster effect. A treble booster is an effects unit used by guitarists to boost volume and especially the high end of their tonal spectrum, and was popular mostly during the 1960s. VOX made a variety of boosters that were meant to be plugged directly… Read More »
The following is a circuit of a simple AM transmitter. This circuit is available in kit form and can work well since the kit available on market. This circuit uses a combination of transistors SA101 and SA103, as the modulation signal amplifier.
This is the scheme diagram of passive surround circuit. Passive surround doesn’t need any active components and power supply to make the circuit works. The circuit just need the combination of resistors and electrolytic capacitors. Circuit Notes: This passive surround circuit MUST be connected after power amplifier module. Use full range type of loudspeaker. Do… Read More »
The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »
This is a stereo VU booster circuit diagram based on transistor FCS9014 which usually used for pre-amp and regulator circuit and switching. With simple circuit design, this device could be built easily. Scheme diagram, bottom PCB layout and component placement provided on the following image: This circuit should be connected to audio channel before amplifier… Read More »