This is a very simple FM receiver which build based on one transistor only. No chip or another active component. The output is connected to earphones, you need an amplifier circuit if you want to listen the radio with a loudspeaker.
This is a motor speed controller circuit diagram built based MAX4295 from Maxim. By using this circuit, you will be able to control the speed of motor movement. Resistor R1 biases the potentiometer to match the input range of U1. Full counter-clockwise rotation of the pot corresponds to maximum-speed reverse rotation of the motor. Mid-scale… Read More »
Here is the AM Radio receiver circuit diagram based on old single IC MK484. Components List: R9, R10_________ 6R8 R6_____________ 100R R3_____________ 1K R1_____________ 4K7 R7_____________ 5K6 R4_____________ 10K R2_____________ 100K R5_____________ 150K R8_____________ 820K Pot_____________ 10K log pot Coil & ferrite bar set C7______________ 470p ceramic C, C4, C5, C6_____ 470nF monoblock C2______________ 100nF… Read More »
This circuit is a powerful three stage, 9V FM transmitter (Tx) with a range of up to 1 kilometer in the open. It uses an RF transistor in its output stage and two BC547″s for the first two stages. Distance of trans-mission is critically dependent on the operating Conditions (in a building or out on… Read More »
This a two station intercom. It uses two wires to run between each intercom unit. Each is self contained with its own battery, speaker, microphone and amplifier circuit. An LM386 audio power amplifier is used. It is widely available, used a minimum of external parts and is well suited to battery operation. It will give… Read More »
This is the circuit diagram of UHF band TV antenna booster with 15dB gain power. This low cost antenna booster is simple and easy to build.It use single transistor BF180 to boost te UHF signal. Since this is an active circuit of UHF TV antenna booster, it will require a 12v power supply to operate.… Read More »
This is the circuit of LED color fade effect. Just like the name of the circuit, the light intensity of LEDs in this circuit will fade from high intensity to low intensity and then off. Here the final result preview:
This is long range FM transmitter with transmision power output is up to 15W. This 15W FM transmitter use power transistor BLY88C as the main transmitter amplifier. Building a good FM transmitter(88-110Mhz) begins with getting a good schematic. You don’t have to understand the precise working of the transmitter to build it. But some basic… Read More »
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram: