This 2x10W audio amplifier circuit power output will be 10 watt on each channel with 4 ohm speaker resistance. The supply voltage required for this circuit is 8 – 24V DC at 1 to 2 Amps. Maximum output power will only be obtained with a power supply of at least 20V and greater than 1.5… Read More »
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram:
This is a 18 Watt audio amplifier circuit based on power IC HA13118. The supply voltage required for this circuit is 8 – 18V DC, at least 1 to 2 Amps. Maximum output power will only be obtained with a power supply of 18V at greater than 2 A, using a 4 ohm speaker. The… Read More »
This is an amplifier circuit with gain music output power up to 7W. It uses IC TDA2003 as main component. This 7 watt audio amplifier circuit is small but powerful multi purpose amplifier. IC TDA2003 provides a high output current capability (up to 3.5A) very low harmonic and cross-over distortion.
This is 2 x 3W stereo audio amplifier based on IC power BA5406. This circuit which will give you 3W power in each channel. This circuit will be great for indoor audio system. Components List: R1, R2 = 120 ohm R3, R4 = 2R2 ohm C1, C2, C11, C12 = 220nF nonpolar capacitor C3, C4,… Read More »
This is 2x1W stereo amplifier circuit based on single IC KA2209. IC KA2209 is an equivalent IC to the TDA2822, you can use TDA2822 if you can’t find KA2209. It is ideal for battery powered operation since the supply required for this circuit is 2V to 9VDC. Power output depends critically on speaker resistance &… Read More »
This is 1W stereo audio amplifier with LM386N. The output power is 1 watt for each channel, so it should be use two ICs of LM386N National Semiconductor for stereo channel. This circuit belongs to kitsrus.com and the kit is available there or at electronickits.com. This circuit only need 10mA current with best voltage supply… Read More »
This is the circuit diagram of 1W audio amplifier which use TDA7052 as the main component and other 5 pieces of components to support the main component. The ideal supply voltage of this circuit is about 6-12V and no heatsink required. The schematic is for mono audio channel, just build two similar circuit for stereo… Read More »
Flame, gas and smoke detector for fire alarm. You can combine this circuit with alarm circuit. The output will be the relay which switch on and switch off the alarm. Schematic diagram: