This is another 100 watt inverter circuit diagram. Built based on IC CD4047 and Mosfet IRF540, this inverter have ability to supply electronic device -which require 220VAC- up to 100w from 2-3A transformer from 12V lead acid battery. In the circuit diagram we can observe that 12V battery is connecter to the diode LED and… Read More »
Here the simple and low cost FM transmitter which powered using two transistors. This circuit may be tuned to operate over the range 87-108MHz with a range of 20 or 30 metres. The circuit works with 9V power supply, use regulated power supply for better quality. The coil L1 was consist of 7 turns on… Read More »
This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp. For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:
Here is the circuit diagram of the classic 5W Tube Amplifier with EL84 as the final amplification component. This is a single channel amplifier (mono) of course with single input and single output. You should build the two similar circuit to make it stereo.
This is a simple, well designed 1.5 Watt FM Transmitter circuit using power transistor 2N2219A. This circuit should be able to cover 1-2 KM range. It use +5-30V power supply to work. Refer to the above diagram, the input source is an electret condenser microphone (you may try to use other input sources) and signal… Read More »
This is the circuit diagram of sound effects generator. All sounds in this circuit are generated by HT2884. The HT2884 is a CMOS LSI chip equipped with tone circuit, noise circuit, and other control logic to generate various sounds to be used in sound effects production. This IC features: single power supply (2.4V – 3.3V),… Read More »
This is electronic bird chirp sound generator circuit which used to produce a sound like bird’s chirp. The transformer is a small audio transformer, type LT700. The primary is center tapped with an impedance of 1Kohms at 1KHz . The secondary has an impedance of 8 ohms. The circuit works with 9V power supply.
This is Electronic Siren circuit diagram which use standard discrete components. The sound produced imitates the rise and fall of an American police siren. When first switched on the 10u capacitors is discharged and both transistors are off. When the push button switch is pressed to 10u capacitor will charge via the 22k resistor. This… Read More »
This is simple portable audio amplifier circuit. This circuit built based on IC TEA2025 which is a monolithic integrated audio amplifier in a 16-pin plastic dual in line package manufactured by UTC. Circuit has Internal Thermal Protector. It is designed for portable cassette players, mp3 players and radios. You can also use it as your… Read More »