This is the design diagram of 5 band graphic equaliser circuit build using operational amplifier chips, the NE5532 or LM833. The op-amp ICs is a good choice because of inexpensive and comes with fairly good quality output. Each IC contains dual op-amps circuit, so you will need 4 ICs of NE5532 or LM833 to build… Read More »
Designed by Don Tillman, this guitar pre-amp circuit design is dedicated for people who don”t like op-amps module. This circuit is a discrete JFET pre-amplifier design, use 2N5457 as the main component. It has low noise, low distortion, low feedback, overloads gracefully, is small, etc.
The following scheme is the clock generator circuit diagram which build based on NAND Gate logic IC. You may use IC 7400 or 4011 for this circuit. The 7400 is a Transistor-Transistor Logic (TTL) type, while 4011 is Complementary metal–oxide–semiconductor (CMOS) type. IC 4011 is cheaper than 7400 but the 7400 is faster than 4011.… Read More »
The following scheme diagram is the battery charger circuit for 6V Gel Cell battery type only. Components List: R1 = 22 ohm, 1W R2 = 270 ohm R3 = 220 ohm *R4 = 715 ohm, 1% *R5 = 3.57K, 1% *R6 = 1.40K, 1% *R7 = 1.47K, 1% C1 = 0.1uF, ceramic C2 = 0.1uF,… Read More »
The following diagram is the circuit diagram of low cost 12V stereo tone control which also available in kit, you may find the kit at electronic part store around your place. The circuit build based on ordinary tone control circuit, using two low cost transistors FCS9014 in each channel, so there are will be four… Read More »
The circuit below is a Dynamic Mic Compressor circuit which is simple, easy to built, inexpensive but the results are quite satisfactory. Audio output sounded outstanding. The principle of this circuit is very simple, the first transistor is used as microphone pre-amplifier. Then a second transistor used as a buffer. And the third transistor is… Read More »
This is a very basic circuit diagram of 3 band tone control. This basic tone control circuit was originally intended for home audio use, but should be able to be hacked into an effect circuit with very minor modification. Resistance value of resistor R1 is left up to the user depending on gain needs, R2… Read More »
This is Dan Armstrong Green Ringer guitar effect for your electric guitar. The guitar effect is sold at high price at the market. Now, you can build your own low cost guitar effect… 🙂 The transistor marked ” * ” has no markings other than three stripes: green, blue and white from top to bottom.… Read More »
The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »