This is a inexpensive high fidelity (hi-fi) tone control circuit designed just with two low cost transistors as the active components. The schematic is one channel (mono) tone control, build the similar circuit will make it become stereo channel. This Hi-Fi tone control circuit can be operated with wide range supply voltage, 12V – 24V… Read More »
This is an audio mixer circuit which designed along with VU meter circuit. The circuit is for one channel input, if you need, for example 5 channel mixer, then you need to build 5 similar circuits. The this audio mixer uses three potensiometers to adjust volume level, low frequency (bass) level and high frequency (treble)… Read More »
The following diagram is the circuit diagram of 20 band stereo graphic equaliser which will controlling the audio signal in specific frequency range. The power supply used for this circuit is symmetrical (dual polarity) type, 15V DC.
Below is a 80W audio amplifier circuit is constructed by using a power IC TDA7295. With a very simple design, makes this circuit very easy to build. TDA7295 has many features to support your audio system, the most important is that the IC has very low distortion and very low noise feature. Schematic diagram: PCB… Read More »
This is the circuit diagram of UHF band TV antenna booster with 15dB gain power. This low cost antenna booster is simple and easy to build.It use single transistor BF180 to boost te UHF signal. Since this is an active circuit of UHF TV antenna booster, it will require a 12v power supply to operate.… Read More »
Here is the dynamic microphone amplifier circuit diagram. This circuit should be perfect for dynamic microphone… Dynamic microphones are versatile and ideal for general-purpose use. They use a simple design with few moving parts. They are relatively sturdy and resilient to rough handling. They are also better suited to handling high volume levels, such as… Read More »
This is long range FM transmitter with transmision power output is up to 15W. This 15W FM transmitter use power transistor BLY88C as the main transmitter amplifier. Building a good FM transmitter(88-110Mhz) begins with getting a good schematic. You don’t have to understand the precise working of the transmitter to build it. But some basic… Read More »
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram:
This is a 18 Watt audio amplifier circuit based on power IC HA13118. The supply voltage required for this circuit is 8 – 18V DC, at least 1 to 2 Amps. Maximum output power will only be obtained with a power supply of 18V at greater than 2 A, using a 4 ohm speaker. The… Read More »