This is an amplifier circuit with gain music output power up to 7W. It uses IC TDA2003 as main component. This 7 watt audio amplifier circuit is small but powerful multi purpose amplifier. IC TDA2003 provides a high output current capability (up to 3.5A) very low harmonic and cross-over distortion.
This is 2 x 3W stereo audio amplifier based on IC power BA5406. This circuit which will give you 3W power in each channel. This circuit will be great for indoor audio system. Components List: R1, R2 = 120 ohm R3, R4 = 2R2 ohm C1, C2, C11, C12 = 220nF nonpolar capacitor C3, C4,… Read More »
This is a HiFi pre-amplifier circuit diagram with low noise output. Very wide range frequency from about 10Hz until up to 100Khz will be gained by this preamplifier for maximum audio performance. This circuit uses BC550C / BC560C transistors as active component. Use regulated power supply 15VDC for maximum result.
This 4W Audio Amplifier circuit is powered by 2 pieces of transistor TIP41. The circuit is very simple and incorporates darlington output transistors that will provide more than enough output current than is needed to drive a 3-ohm speaker. The 4W audio amplifier circuit is very simple and incorporates darlington output transistors that will provide… Read More »
This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp. For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:
This is high fidelity, high quality 25W HiFi audio amplifier circuit delivers great audio performance. You don’t need pre amplifier circuit for this design since it can be directly connected to the input devices such as computers, phones, radios, TVs, etc. Component list: R1,R4 = 47K 1/4W Resistors R2 = 4K7 1/4W Resistors R3 =… Read More »
This is the scheme diagram of 20 Watt stereo audio amplifier which use dual IC TDA2005, one IC for left channel and the another one for right channel. Each IC will give you 20 watt output, so the output will be 2×20 Watt. The supply voltage for this circuit is 8VDC to 18VDC, use regulated… Read More »
This is 20 watt audio amplifier circuit design which use IC LM1875 as main component. This circuit is simple and very easy to built. For stereo channel, you need to build the two same circuits which will amplify the both of audio channels (right and left channel). Dual polarity / symmetrical power supply required for… Read More »
Here the SW transmitter circuit based on IC BEL1895. This particular transmitter circuit works in shortwave HF band (6 MHz to 15 MHz), and can be applied for shortrange communication and for educational purposes. The circuit is composed of a mic amplifier circuit, a variable frequency oscillator, and modulation amplifier stages. Transistor T1 (BF195) is… Read More »