This is a 60W AF power amplifier based on single Sanyo integrated circuit STK-0060II. This circuit delivers 60W mono/single channel audio output. For stereo channel, you may build two identical circuits and of course doubled the power supply current (use 5A transformer for stereo application). The amplifier circuit uses symmetrical (dual polarity) power suppy. Recommended… Read More »
Here the 50W AF power amplifier circuit powered with single IC STK4036II. This circuit will deliver 50W single channel output. The amplifier circuit uses symmetrical (dual polarity) power suppy. Recommended power supply voltage is +/- 35VDC. Use heatsink to prevent overheating on the IC and maximize the STK4036II performance.
Here the another audio amplifier circuit with single power IC from Phillips, TDA1514A. This is a hi-fi power amplifier circuit with 50W power output. A power IC delivers 50W single power output, then you need to build two similar circuit for stereo application. The TDA1514A integrated circuit is a hi-fi power amplifier for use as… Read More »
This is a class AB 6-10W audio power amplifier circuit which built using a TDA2002 or TDA2003 power amplifier IC module. These are replacements for the original LM383 which is no longer available. It is easy to build and has a minimum of external components. The module has both short circuit protection and thermal protection.… Read More »
Here the circuit diagram of 25 watt Hi-Fi (high fidelity) audio amplifier that build based on single power amplifier IC LM1875 that should be run using heatsink attached on its. Components List: R1 _____________ 1K R2 _____________ 1M R3 _____________ 22K R4 _____________ 10K R5 _____________ 180K R6 _____________ 1R IC1 ____________ LM1875 C1 _____________… Read More »
This 2x10W audio amplifier circuit power output will be 10 watt on each channel with 4 ohm speaker resistance. The supply voltage required for this circuit is 8 – 24V DC at 1 to 2 Amps. Maximum output power will only be obtained with a power supply of at least 20V and greater than 1.5… Read More »
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram:
This is the circuit diagram of 1W audio amplifier which use TDA7052 as the main component and other 5 pieces of components to support the main component. The ideal supply voltage of this circuit is about 6-12V and no heatsink required. The schematic is for mono audio channel, just build two similar circuit for stereo… Read More »
Here the circuit diagram of 50W power amplifier. The amplifier uses a pair of power transistors that are MJ2955 and 2N3055 to amplify the input signal. You must use a heatsink on those transistors. The below design diagram uses for single input/output channel, just built two similar circuit to make it dual channel (stereo). Schematic… Read More »