Here the circuit diagram of 50W power amplifier. The amplifier uses a pair of power transistors that are MJ2955 and 2N3055 to amplify the input signal. You must use a heatsink on those transistors. The below design diagram uses for single input/output channel, just built two similar circuit to make it dual channel (stereo). Schematic… Read More »
Here the analog flip-flop circuit which built based on 2 transistors work as switch. This is very easy made and very cheap circuit. You can use this circuit as “the first project” for your students… 🙂 and the result should be like this:
This is the simple and low cost AM transmitter schematic diagram built using transistor BC109C. The circuit is in two halfs, an audio amplifier and an RF oscillator. The oscillator is built around Q1 and associated components. The tank circuit L1 and VC1 is tunable from about 500kHz to 1600KHz. These components can be used… Read More »
Here the simple and low cost FM transmitter which powered using two transistors. This circuit may be tuned to operate over the range 87-108MHz with a range of 20 or 30 metres. The circuit works with 9V power supply, use regulated power supply for better quality. The coil L1 was consist of 7 turns on… Read More »
This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp. For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:
Here is the circuit diagram of the classic 5W Tube Amplifier with EL84 as the final amplification component. This is a single channel amplifier (mono) of course with single input and single output. You should build the two similar circuit to make it stereo.
This is the circuit diagram of 35W Tube Power Amplifier with EL34. This tube amplifier designed in 1953 and worked from 1954 until 1989. If you’re interested with classic circuit and classic components, then you should try this circuit. The circuit is interesting but i think it is hard to find the tubes. Schematic Diagram:
This is the inverter circuit which capable to convert 12V DC to 220V AC dan handle about 50 Watts small electronic appliances. With this circuit, you can use a 12V accumulator / lead acid battery to operate some of your electronic appliances which not exceed 50W of total power consumption. Components List: R1=10Mohms R2=100ohms R3=1.2Kohms… Read More »
This is a simple, well designed 1.5 Watt FM Transmitter circuit using power transistor 2N2219A. This circuit should be able to cover 1-2 KM range. It use +5-30V power supply to work. Refer to the above diagram, the input source is an electret condenser microphone (you may try to use other input sources) and signal… Read More »