3V Strobe Light Miniature

3V Strobe Light Miniature Circuit Diagram

This is the circuit diagram of 3V strobe light miniature. The strobe lights are generally used to create nice looking visual effects in disco halls and auditoria. This post explain how to build the circuit of a battery operated portable miniature strobe light, using inexpensive components.

For convenience and simplicity, an ordinary neon lamp is used here in place of the conventional Xenon tube. The whole gadget can thus be easily mounted in a small cabinet, such as a mains adaptor cover, with a suitable reflector for neon lamp to give a proper look. Because of the electric current need of this circuit is very small, it may be powered by two medium-size dry cells (3V) or Ni-Cd cells (2.4V).

Transistors T1 and T2 in the circuit form a complimentary-pair amplifier. When switch S1 is momentarily depressed, the circuit oscillates because of the positive feedback provided via resistor R2 and capacitor C1 to the base of transistor T1. The sharp pulses in the secondary windings induce a high voltage in primary windings of transformer X1, which in fact is a line driver transformer (used in reverse) generally used in 36cm TV sets.

High voltage pulses induced in primary side are rectified by diode D1 and rapidly charge reservoir capacitor C2 to nearly 300V DC. When switch S1 is released, capacitor C2 holds the voltage level for a finite period while capacitor C3 charges slowly through resistor R3. When voltage across capacitor C3 becomes high enough, neon strikes and the capacitor rapidly discharges through the lamp. When voltage across capacitor C3 falls below the extinguishing potential of neon lamp, it goes off and capacitor C3 starts charging again. This cycle keeps on repeating for a short time, based on the reservoir capacitor C2’s value.

Warning: The neon lamp flasher section of this 3V strobe light miniature circuit carries dangerously high voltages. All precautions should therefore be taken for protection. Before any repair work, discharge capacitor C2 using a short length of wire with a 100k resistor connected in series. Use this circuit with your own risk.


Leave a Reply

Your email address will not be published. Required fields are marked *