500W RMS Power Amplifier Based MOSFET

500W RMS Power Amplifier Circuit based Mosfet

This is 500W RMS power amplifier circuit design, build based on MOSFET. The circuit is very popular in EE audio hobbyist as “LEGEND stage Master MK2”. It is a very good and powerful amplifier. It uses 12x power MOSFET IRFP240.

To achieve even greater power, and they were often interested young friends, was developed even stronger version is capable of producing a full and true 500W RMS into 8 ohms. With such large forces had to resort to a radically different solution some degree, for even better reliability, or has increased the complexity of the tiles so that for this version is impossible to use the same tile as the previous two lower models (Legend and Legend Stage Master).


Output power ——— 500W RMS / 8 ohms
Frequency range 15Hz-130kHz (-1dB) at 30W RMS
THD = <0.18% (at 1 kHz and 500 W)
THD = <0.01% (at 1 kHz and 400W and below this power)
BIAS around 25mA per output pair

500W RMS Power Amplifier PCB Design and Layout

This is the PCB design and component placement, you should mount the MOSFET on the heatsink to prevent overheating and maintain the performance of power amplifier.
500W RMS Power Amplifier PCB Design

500W RMS Power Amplifier Top PCB Layout

This circuit designed by Dr Borivoje Jagodic >> original page for the reference.

Incoming Search: schematic diagram bridge power amplifier, legend stage master mk2 schematic, mosfet amp pcb design, layout driver amplifier, 500w amplifier layout, 500 amplifier mosfet sheme, All pcb power amplifier circuit 2000w, ampi 500w di pcb, power amp circuit with pcb, Mosfet power amp 125 watts by Dr Jagodic, namec amplifier

One thought on “500W RMS Power Amplifier Based MOSFET

  1. Pingback: 250W RMS Power Amplifier Legend Stage Master - Schematic Design

Leave a Reply

Your email address will not be published. Required fields are marked *