Color Detector

This is the color detector / sensor circuit diagram. This circuit will sense eight colors that are: green, red and blue (as primary colours); magenta, cyan and yellow (as secondary colours); and black and white. It’s will be very useful for robotics project.

Color Sensor circuit diagram

The circuit is based on the fundamentals of optics and digital electronics. The object whose colour is required to be detected should be placed in front of the system. The light rays reflected from the object will fall on the three convex lenses which are fixed in front of the three LDRs. The convex lenses are used to converge light rays. This helps to increase the sensitivity of LDRs. Blue, green and red glass plates (filters) are fixed in front of LDR1, LDR2 and LDR3 respectively. When reflected light rays from the object fall on the gadget, the coloured filter glass plates determine which of the LDRs would get triggered.

The circuit makes use of only “AND” gates and “NOT” gates. When a primary coloured light ray falls on the system, the glass plate corresponding to that primary colour will allow that specific light to pass through. But the other two glass plates will not allow any light to pass through. Thus only one LDR will get triggered and the gate output corresponding to that LDR will become logic 1 to indicate which colour it is. Similarly, when a secondary coloured light ray falls on the system, the two primary glass plates corres- ponding to the mixed colour will allow that light to pass through while the remaining one will not allow any light ray to pass through it. As a result two of the LDRs get triggered and the gate output corresponding to these will become logic 1 and indicate which colour it is.

When all the LDRs get triggered or remain untriggered, you will observe white and black light indications respectively. Following points may be carefully noted :

  1. Potmeters VR1, VR2 and VR3 may be used to adjust the sensitivity of the LDRs.
  2. Common ends of the LDRs should be connected to positive supply.
  3. Use good quality light filters.

The LDR is mounted in a tube, behind a lens, and aimed at the object. The coloured glass filter should be fixed in front of the LDR as shown in the figure. Make three of that kind and fix them in a suitable case. Adjustments are critical and the gadget performance would depend upon its proper fabrication and use of correct filters as well as light conditions


5 thoughts on “Color Detector

  1. ashritha

    May i get some information about the pin configurations of IC-4073B, IC-4069B, Which are used in this circuit

  2. pundalik

    1)I am a student doing electronics engineering and am interested in implementing this circuit.may i know if i can get the ready made arrangement of the lens and filters??
    2)information on IC CD4069 and IC CD4073
    colour sensor circuit dot diagram,uses and unuses

  3. Bhavya.B.S.

    I am a student doing electronics engineering and am interested in implementing this circuit.may i know if i can get the ready made arrangement of the lens and filters??

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.