Equaliser circuits typically divide the audio spectrum into separate frequency bands and have independent gain control for each band. The output of each band is mixed at IC4(A) and then fed to an audio power amplifier. Proper quality factor (Q) needs to be selected to avoid overlap in adjacent bands as this introduce colouration into… Read More »
The following is an electronic circuit called galaxy audio booster which serves to improve the performance of your audio system. This circuit uses an IC RC4558 in which there are two op-amp modules that can be used for stereo audio applications. The circuit is similar to stereo tone booster that uses the principle of High… Read More »
Here the SW transmitter circuit based on IC BEL1895. This particular transmitter circuit works in shortwave HF band (6 MHz to 15 MHz), and can be applied for shortrange communication and for educational purposes. The circuit is composed of a mic amplifier circuit, a variable frequency oscillator, and modulation amplifier stages. Transistor T1 (BF195) is… Read More »
This is the circuit diagram of mic condenser amplifier. The low-cost and compact mic condenser audio amplifier described right here is deliver good-quality audio of 0.5 watts at 4.5 volts. It could possibly be applied as a part of low-power transmitters, packet radio receivers, intercoms and walkie-talkies.
This is the design diagram of 5 band graphic equaliser circuit build using operational amplifier chips, the NE5532 or LM833. The op-amp ICs is a good choice because of inexpensive and comes with fairly good quality output. Each IC contains dual op-amps circuit, so you will need 4 ICs of NE5532 or LM833 to build… Read More »
This is a class AB 6-10W audio power amplifier circuit which built using a TDA2002 or TDA2003 power amplifier IC module. These are replacements for the original LM383 which is no longer available. It is easy to build and has a minimum of external components. The module has both short circuit protection and thermal protection.… Read More »
Here the schematic diagram of 6-10W stereo power audio amplifier with IC TDA2005: Components List: R1, R9 ________ 1K ohm R2 ____________ 120K ohm R3, R4 ________ 1K2 ohm R5, R6 ________ 33 ohm R7, R8 ________ 1 ohm IC ____________ TDA2005 Pot ___________ 10K ohm stereo C1 C2 __________ 2u2/50V C3 _____________ 10uF/25V C5,… Read More »
This 2x10W audio amplifier circuit power output will be 10 watt on each channel with 4 ohm speaker resistance. The supply voltage required for this circuit is 8 – 24V DC at 1 to 2 Amps. Maximum output power will only be obtained with a power supply of at least 20V and greater than 1.5… Read More »
This is a 18 Watt audio amplifier circuit based on power IC HA13118. The supply voltage required for this circuit is 8 – 18V DC, at least 1 to 2 Amps. Maximum output power will only be obtained with a power supply of 18V at greater than 2 A, using a 4 ohm speaker. The… Read More »