This is a low cost, simple, yet a surprisingly powerful electronic siren powered by just a 9V battery. The circuit may provide the final circuit block module in an alarm circuit using a relay to activate it.
This is a simple audio pre-amplifier circuit using single transistor 2N3904. This easy circuit provides good gain to weak audio signals such as electret microphone. Use it in front of an RF oscillator to make an RF transmitter that’s very sensitive to sound. Power supply used for this circuit is wide range from 3VDC to… Read More »
Here the SW transmitter circuit based on IC BEL1895. This particular transmitter circuit works in shortwave HF band (6 MHz to 15 MHz), and can be applied for shortrange communication and for educational purposes. The circuit is composed of a mic amplifier circuit, a variable frequency oscillator, and modulation amplifier stages. Transistor T1 (BF195) is… Read More »
This is the simple and low cost pulse width modulation – PWM DC motor controller using a MOSFET. This kind connection for DC motor control is to prevent heat and minimize the power consumption. It controls the motor speed by driving the motor with short pulses. These pulses vary in duration to change the speed… Read More »
This is the circuit diagram of 12 Volts, 4 Amperes Solar Photovoltaic (PV) battery charger which will be suit to charge a 12V battery or accumulator. The circuit handles up to 4 amps of current from a solar panel, which equates to about 75 watts of power. A charging algorithm called “pulse time modulation” is… Read More »
Here the simple schematic of multitone siren alarm circuit. This multitone siren is effective for reverse horns, burlgar alarms, and many others. It generates five various audio tones and is much more earcatching than a single-tone siren.
This is the FM transmitter circuit which apply 4 radio frequency stages, that are a VHF oscillator designed around transistor BF494 (T1), a preamplifier designed around transistor BF200 (T2), a driver designed around transistor 2N2219 (T3) and also a power amplifier designed around transistor 2N3866 (T4). A condenser microphone is wired at the input of… Read More »
This is the very simple way to play a song with single 1.5 battery. You can build this circuit for gift acceccories. When the gift opened, then a song will be played.. It’s easy and cheap right..? 😀 . It just use a single small chip which will generate a song which already planted inside… Read More »
This is the circuit diagram of UHF band TV antenna booster with 15dB gain power. This low cost antenna booster is simple and easy to build.It use single transistor BF180 to boost te UHF signal. Since this is an active circuit of UHF TV antenna booster, it will require a 12v power supply to operate.… Read More »