This is the circuit diagram of portable mic preamp. This circuit consumes low current supply (about 2mA), so will have a long battery life for supplying the circuit. Harmonic distortion is about 0.1% @ 1V RMS output for all frequencies. Maximum input voltage (level control cursor set at maximum) = 25mV RMS. Maximum input voltage… Read More »
This is a HiFi pre-amplifier circuit diagram with low noise output. Very wide range frequency from about 10Hz until up to 100Khz will be gained by this preamplifier for maximum audio performance. This circuit uses BC550C / BC560C transistors as active component. Use regulated power supply 15VDC for maximum result.
This 4W Audio Amplifier circuit is powered by 2 pieces of transistor TIP41. The circuit is very simple and incorporates darlington output transistors that will provide more than enough output current than is needed to drive a 3-ohm speaker. The 4W audio amplifier circuit is very simple and incorporates darlington output transistors that will provide… Read More »
Here the circuit diagram of 50W power amplifier. The amplifier uses a pair of power transistors that are MJ2955 and 2N3055 to amplify the input signal. You must use a heatsink on those transistors. The below design diagram uses for single input/output channel, just built two similar circuit to make it dual channel (stereo). Schematic… Read More »
This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp. For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:
Here is the circuit diagram of the classic 5W Tube Amplifier with EL84 as the final amplification component. This is a single channel amplifier (mono) of course with single input and single output. You should build the two similar circuit to make it stereo.
This is the circuit diagram of 35W Tube Power Amplifier with EL34. This tube amplifier designed in 1953 and worked from 1954 until 1989. If you’re interested with classic circuit and classic components, then you should try this circuit. The circuit is interesting but i think it is hard to find the tubes. Schematic Diagram:
This is simple portable audio amplifier circuit. This circuit built based on IC TEA2025 which is a monolithic integrated audio amplifier in a 16-pin plastic dual in line package manufactured by UTC. Circuit has Internal Thermal Protector. It is designed for portable cassette players, mp3 players and radios. You can also use it as your… Read More »
Here is the 100W RMS audio amplifier schematic diagram: This circuit is quite simple but will give you high quality audio output. Take a note that above diagram designed for single input and single output (mono system). For stereo system, you need to build two similar circuits.