This is the circuit diagram of DOD FX75 Flanger guitar effect pedal. The circuit drawn by Fabian P. Hartery. Featuring a Width control and two output jacks, the FX75 was much more versatile than its predecessor, but the flanging effect it could provide was still not very intense. That said, chorus-like washes of flange can… Read More »
The following diagram is the schematic diagram of 4 transistors FM transmitter circuit designed by Paul K. Sherby. Components List: R1,R2,R8 = 1K R3 = 100K R4 = 150K R5,R7 = 10K R6 = 220 ohm R9 = 10 ohm P1 = 5K trimpot D1 = 1N4002 Q1,Q2 = 2N3904 Q3,Q4 = 7001, NTE123AP C1… Read More »
In the above circuit diagram, a CMOS operational amplifier (op-amp) controls the current via a P-Channel HEXFET power transistor (IRF9520) to maintain a constant voltage across R1. The current is given by: 1 = VREF/R1. The benefits of this configuration are:
The following diagram is an inverter circuit which will give you 220V AC 50Hz with maximum power output of 100W. This inverter built using transistors for both the square wave generator module and the amplifier module. Inverter Diagram: The Q1 and Q2 used generate square wave. Q5-Q8 amplify the signal and the transformer to increase… Read More »
Designed by Don Tillman, this guitar pre-amp circuit design is dedicated for people who don”t like op-amps module. This circuit is a discrete JFET pre-amplifier design, use 2N5457 as the main component. It has low noise, low distortion, low feedback, overloads gracefully, is small, etc.
Here the simple mixer circuit with 4 inputs and 2 operational amplifier (op-amp) modules: A basic mixer suitable for mixing microphones or even effects outputs. The overall gain from input to output is one if the pot related towards the input is full up. You can make this a net gain of ten (or any… Read More »
Below circuit is the tone booster circuit. According to the name of circuit, the purpose is to amplify the sound signal to become more powerful in both low and high frequencies. There is no potensiometer used for bass/treble adjustment. Transistor type: Q1 – ztx384 ; Q2 – BC415p The circuit’s peaks frequencies is at 5000… Read More »
The following diagram is the circuit diagram of low cost 12V stereo tone control which also available in kit, you may find the kit at electronic part store around your place. The circuit build based on ordinary tone control circuit, using two low cost transistors FCS9014 in each channel, so there are will be four… Read More »
The circuit below is a Dynamic Mic Compressor circuit which is simple, easy to built, inexpensive but the results are quite satisfactory. Audio output sounded outstanding. The principle of this circuit is very simple, the first transistor is used as microphone pre-amplifier. Then a second transistor used as a buffer. And the third transistor is… Read More »